Medium Impact ABS, Low Gloss Sheet
Introduction
ALLEN® 2035LG is a general purpose ABS with medium impact and a low gloss finish.
General
Information
ALLEN® 2035LG has been tested under laboratory conditions and has achieved a UL94 HB rating at 0.060 in (1.52mm) and above and meets the requirements of Federal Motor Vehicle Safety Standard No. 302 (FMVSS 302).
Suggested
Applications
- Medical Equipment Housings
- Food Equipment Trays & Housings
- Display
- Signs
Features
- Custom color matching
- Good forming and fabricating properties
- Edge trim easily used in future orders
- Low gloss finish
Environmental
& Safety
Considerations
SEKISUI KYDEX®, LLC is committed to ensuring that its products can be manufactured, transported, stored, used, disposed and recycled with an appropriate regard for safety, health and environmental protection. We support the safe handling of our products. Please contact our Technical Service department at 800.682.8758 for resources or visit our website: http://www.kydex.com. For Material Safety Data Sheets, please call 800.325.3133.
| Property | Test Method | Typical Value1 | |
|---|---|---|---|
| PHYSICAL | |||
| Specific Gravity | ASTM D792 | 1.05 g/cc | |
| Gloss, 60° Angle | ASTM D523 | 50-70% | |
| MECHANICAL | |||
| Tensile Strength | ASTM D638 | 5,200 psi | 35.8 MPa |
| Flexural Modulus | ASTM D790 | 290,000 psi | 1,999.4 MPa |
| Flexural Strength | ASTM D790 | 8,600 psi | 59.2 MPa |
| Notch Izod Impact, 73°F | ASTM D256 | 4.9 ft-lbs/in | 261 J/m |
| Notch Izod Impact, 0°F | ASTM D256 | 2.4 ft-lbs/in | 128 J/m |
| THERMAL | |||
| Heat Deflection Temperature (HDT) @66 psi (0.45 MPa), unannealed | ASTM D648 | 200 °F | 93.4 °C |
| Heat Deflection Temperature (HDT) @264 psi (1.8 MPa), unannealed | ASTM D648 | 190 °F | 87.8 °C |
| Mold Shrinkage | ASTM D955 | 0.004-0.007 in/in | |
| FLAMMABILITY | |||
| Underwriters Laboratories., Inc ® Component Recognition | UL Standard 942 | HB @ 0.060 in (1.52mm) | |
| Motor Vehicle Safety Standard | Component Recognition | PASS | |
| 1 Values based upon injection molded resin 2 ALLEN® 2035LG has been tested under laboratory conditions and has passed UL 94HB criteria. SEKISUI SPI makes no warranty or guarantee that these prod- ucts will meet UL 94HB in the part’s final, finished configuration. Not intended for specification purposes. | |||