Co-extruded, Medium Impact, Low Gel, Medium Gloss Sheet
Introduction
ALLEN® 2012L is a general purpose ABS that has medium impact strength and a good cost to performance ratio to other materials like painted metal, FRP, aluminum, and other thermoplastics.
General
Information
ALLEN® 2012L has been tested under laboratory conditions and meets the requirements of Federal Motor Vehicle Safety Standard No. 302 (FMVSS 302).
Suggested
Applications
- Marine products
- Recreational Vehicles
- Agricultural cab interiors
- Truck interiors
- Equipment covers
- P.O.P Displays
- Film laminations
Features
- Edge trim easily used in future orders
- Medium gloss finish
Environmental
& Safety
Considerations
SEKISUI KYDEX®, LLC is committed to ensuring that its products can be manufactured, transported, stored, used, disposed and recycled with an appropriate regard for safety, health and environmental protection. We support the safe handling of our products. Please contact our Technical Service department at 800.682.8758 for resources or visit our website: http://www.kydex.com. For Material Safety Data Sheets, please call 800.325.3133.
| Property | Test Method | Typical Value1 | |
|---|---|---|---|
| PHYSICAL | |||
| Specific Gravity | ASTM D792 | 1.05g/cc | |
| Gloss, 60° Angle | ASTM D523 | 80% | |
| MECHANICAL | |||
| Tensile Strength | ASTM D638 | 5,000 psi | 34.4 MPa |
| Flexural Modulus | ASTM D790 | 280,000 psi | 1,930.5 MPa |
| Flexural Strength | ASTM D790 | 8,000 psi | 55.1 MPa |
| Notch Izod Impact, 73°F | ASTM D256 | 4.0 ft-lb/in | 213 J/m |
| Notch Izod Impact, 0°F | ASTM D256 | 2.0 ft-lb/in | 106 J/m |
| THERMAL | |||
| Heat Deflection Temperature (HDT) 66 psi ( 0.45 MPa), unannealed | ASTM D648 | 195°F | 90.6°C |
| Mold Shrinkage | ASTM D955 | 0.005-0.007 in/in | |
| FLAMABILITY | |||
| Motor Vehicle Safety Standard | Component Recognition | Passes | |
| 1 Values based upon injection molded resin Not intended for specification purposes. | |||