Co-extruded, Medium Impact ABS, High Gloss Sheet
Introduction
ALLEN® 2175HG is a general purpose ABS with medium impact and a high gloss finish.
General
Information
ALLEN® 2175HG has been tested under laboratory conditions and has achieved a UL94 HB rating at 0.060 in INFORMATION (1.52mm) and above and meets the requirements of Federal Motor Vehicle Safety Standard No. 302 (FMVSS 302)
Suggested
Applications
- Medical Equipment Housings
- APPLICATIONS • Food Equipment Trays & Housings
- Display
- Signs
Features
- Custom color matching
- Good forming and fabricating properties
- Edge trim easily used in future orders
- High gloss finish
Environmental
& Safety
Considerations
SEKISUI KYDEX is committed to ensuring that its products can be manufactured, transported, stored, used, & SAFETY disposed and recycled with an appropriate regard for safety, health, and environmental protection. We support the safe handling of our products.
Please contact our appLab™ department at 800.682.8758 for resources and Safety Data Sheets or visit our website: www.kydex.com.
| Property | Test Method | Typical Value1 | |
|---|---|---|---|
| PHYSICAL | |||
| Specific Gravity | ASTM D792 | 1.05 | |
| Gloss, 60° Angle | ASTM D523 | 80% | |
| MECHANICAL | |||
| Tensile Strength | ASTM D638 | 5,200 psi | 35.8 MPa |
| Flexural Modulus | ASTM D790 | 290,000 psi | 1,999.4 MPa |
| Flexural Strength | ASTM D790 | 8,600 psi | 59.2 MPa |
| Notch Izod Impact, 73°F | ASTM D256 | 4.9 ft-lb/in | 261 J/m |
| Notch Izod Impact, 0°F | ASTM D256 | 2.4 ft-lbs/in | 128 J/m |
| THERMAL | |||
| Heat Deflection Temperature (HDT) @264 psi (1.8 MPa), unannealed | ASTM D648 | 190°F | 87.8°C |
| Heat Deflection Temperature (HDT) 66 psi ( 0.45 MPa), unannealed | ASTM D648 | 200°F | 93.4°C |
| Mold Shrinkage | ASTM D955 | 0.004-0.007 in/in | |
| FLAMABILITY | |||
| Underwriters Laboratories., Inc ® Component Recognition | UL Standard 942 | HB @ 0.060 in (1.52mm) | |
| Motor Vehicle Safety Standard | Component Recognition | PASS | |
| 1 Values based upon injection molded resin | |||
| 2 ALLEN® 2150HG has been tested under laboratory conditions and has passed UL 94HB criteria. SEKISUI KYDEX makes no warranty or guarantee that these products will meet UL 94HB in the part’s final, finished configuration Not intended for specification purposes. | |||