Co-extruded, Medium Impact ABS, High Gloss Sheet
Introduction
ALLEN® 2170HG is a general purpose ABS that has high gloss, medium impact strength, and a good cost to performance ratio.
General
Information
ALLEN® 2175HG has been tested under laboratory conditions and has achieved a UL94 HB rating at 0.060 in INFORMATION (1.52mm) and above and meets the requirements of Federal Motor Vehicle Safety Standard No. 302 (FMVSS 302)
Suggested
Applications
- Covers and Housings
- APPLICATIONS • Vehicle Interiors
- Display
- Signs
Features
- Custom color matching
- Good forming and fabricating properties
- Edge trim easily used in future orders
- High gloss finish
- UV protective films available
Environmental
& Safety
Considerations
SEKISUI KYDEX is committed to ensuring that its products can be manufactured, transported, stored, used, & SAFETY disposed and recycled with an appropriate regard for safety, health, and environmental protection. We support the safe handling of our products.
Please contact our appLab™ department at 800.682.8758 for resources and Safety Data Sheets or visit our website: www.kydex.com.
| Property | Test Method | Typical Value1 | |
|---|---|---|---|
| PHYSICAL | |||
| Specific Gravity | ASTM D792 | 1.08 | |
| Water Absorption, 24hr | ASTM D570 | 0.27% | |
| Rockwell Hardness, R-Scale | ASTM D785 | 101 | |
| MECHANICAL | |||
| Tensile Strength | ASTM D638 | 5,120 psi | 35.3 MPa |
| Tensile Modulus | ASTM D638 | 293,000 | 2,020 MPa |
| Flexural Modulus | ASTM D790 | 303,000 psi | 2,089.1 MPa |
| Flexural Strength | ASTM D790 | 7,580 psi | 52.3 MPa |
| Compressive Strength, yield | ASTM D695 | 7,540 psi | 52.0 MPa |
| Shear Strength | ASTM D732 | 5,330 psi | 36.7 MPa |
| Bearing Strength, 4% deflection | ASTM D953 | 3,590 psi | 24.8 MPa |
| Bearing Strength, max | ASTM D953 | 24,000 psi | 165.5 MPa |
| Notch Izod Impact, 73°F | ASTM D256 | 3.68 ft-lbs/in | 196.5 J/m |
| Gardner Drop Dart Impact, GE | ASTM D5420 | 220 in-lbf | 24.9 J |
| THERMAL | |||
| Heat Deflection Temperature (HDT) @264 psi (1.8 MPa), unannealed | ASTM D648 | 215.5°F | 102°C |
| Heat Deflection Temperature (HDT) 66 psi ( 0.45 MPa), annealed | ASTM D648 | 220.8°F | 105°C |
| Coefficient of Thermal Expansion (MD) | ASTM E831 | 80.1 μin/in/°F | 44.5 μm/m/°C |
| FLAMABILITY | |||
| Motor Vehicle Safety Standard | Component Recognition | PASS | |
| 1 Values based upon injection molded resin | |||
| 2 ALLEN® 2170HG has been tested under laboratory conditions and has passed UL 94HB criteria. SEKISUI KYDEX makes no warranty or guarantee that these products will meet UL 94HB in the part’s final, finished configuration Not intended for specification purposes. | |||